Help Center > > FAQs> Secondary Development> FAQs About Product Development> Device Development> Command Status Is Not Changed to Successful After a Device Reports the Command Execution Result

Command Status Is Not Changed to Successful After a Device Reports the Command Execution Result

Updated at: Jun 26, 2019 GMT+08:00
On the Developer Center, choose Device Management > Logs, and enable the log function. After the device reports the command execution result, check whether logs are recorded.
  • If no log is recorded, the message does not reach the IoT platform. In this case, check the network and device.
  • If logs are recorded and no error message is displayed, the mid field in the codec may be incorrectly configured. For details on how to use mid, see Codec for Containing Command Execution Results.

Did you find this page helpful?

Submit successfully!

Thank you for your feedback. Your feedback helps make our documentation better.

Failed to submit the feedback. Please try again later.

Which of the following issues have you encountered?







Please complete at least one feedback item.

Content most length 200 character

Content is empty.

OK Cancel